Page 61:

• The exploded view in the drawing shows the width of the front face on each stile as 3/4",it should be 1" wide.

Page 42:

• The back leg detail A shows a measurement of 8 1/2" at the top. This is an error. The leg can be cut from a piece of lumber that's 7 1/2" wide. The width of the leg, from the knee bend to the widest part at the 75 degree base is 7 1/2".

Page 94:

• The dimension of 25mm (1") in the upper section of the drawing indicating the drawer box to side spacing is incorrect. The space should be 12.5mm (1/2") on each side for drawer box to side spacing.

Page 98:

• The back listed in the 3/4" materials list at 22 1/2" by 22 1/2" should be 23 1/4" by 30 1/4". The metric sizes are correct.

Page 41:

• The top chart should is incorrectly labeled. It should be, "Cut List for Base Cabinets"
• Both charts list a top and bottom board incorrectly. There is only a bottom board for a base unit...no top board is required.

Page 95:

• The second chart, "Cut List for Base cabinets Using 3/4" Material" shows a top and bottom board. There is only a bottom board required. The dimensions for bottom board depth is also incorrect...it should be 23 1/4" not the 11 1/4" shown.

Page 46:

• Both side A's should be 22 5/8" for 5/8" material and 22 1/2" for 3/4" material as shown in the cut list

Page 52:

• The height figure shown 31 3/4" should be to the top of the face frame not to the top of the counter - 31 3/4" is the total face frame height

Page 21: Hardware List corrections

• the drawer glide sets required are 16" not 18" long as stated

• use 5" x 3/8" dia. bolts not the 4" length as stated

Page 31:

• part # F should be 3/4" thick, not 1/4" as shown

Page 83:

• part D, rail should be 16 1/2" long
• part Q, drill platform should be 16 1/2" long